AquaCraft King's Ransom - Manual (Page 3)

After opening the box we advise you remove the ship from
the shipping carton using these basic steps:
❏
1. Carefully cut any tape and remove the sail and mast
assembly box, which should be on top.
❏
2. Cut down the sides of the inner box on two (2) of the
four corners.
❏
3. Slide the ship and styrofoam packing out from the box at the
same time. Then remove the keel weight and the transmitter. Cut
any tape and carefully extract the King’s Ransom display stands
from the box.
❏
4. Carefully cut any tape holding the two foam cradle
halves together and extract the hull from the foam and set it
on your display stand.
If you wish, slide the foam back in the box, raise the flap and
put the cover back on the box. Save the box for future moving
or storage.
TRANSMITTER ASSEMBLY
NOTE: The transmitter is not water resistant and should never
come in contact with water.
❏
1. Remove the transmitter antenna from the plastic bag. Screw
the antenna into the hole located at the top of the transmitter. Give
a light tug on the antenna to make sure it is properly installed.
KING'S RANSOM FINAL ASSEMBLY
REMOVING THE SHIP FROM THE CARTON
PLEASE READ ME FIRST
3