Kimber Model 84M - Manual (Page 17)

H. Trigger
The trigger is a single stage mechanism which is set at the factory for
between 3 - 3-1/2 lbs. for Varmint Models and between 3-1/2 and 4 lbs. for
the Classic Models.
It is fully adjustable for over travel, depth of sear engagement and weight of
pull. However, the trigger pull has been set at the factory with proper
overtravel and sear engagement, so we do not recommend disassembly or
adjustment except by a qualified gunsmith or by our factory personnel.
Only experience Kimber gunsmiths should
adjust the trigger mechanism.
Floor Plate
Receiver Screws
Magwell on rifle
G1
G2
17
THEN LIFT UP AND OUT AT SLIGHT ANGLE
FIRST LIFT UP SLIGHTLY
If for some reason the trigger guard must be removed from the stock, the
best way to achieve this is to lightly tap each end of it, fore and aft, with the
tip of a screwdriver from inside the stock.
To return the action to the stock, reverse procedures 1 through 4. Be sure to
tighten the front take down screw first, then the rear screw.