acidlab Autobot - Manual (Page 31)

31
Voltage Supply
The Autobot has to be connected with the delivered 2x8 ribbon-cable to the +/-12V-
powerbus (e.g. Doepfer).
The secound 2x8 multi-pin-connector on the PCB-board can be used for a flying-bus-
wiring.
The lowerpin is connected to the –12V.
It is not necessary to supply the Autobot with a +5V.
The Autobot generates a +5V out of the connected +12V.
The maximum supply current is +12V/80mA and –12V/20mA
+5V-Bus:
If the +5V-Bus of your power-bus is not in use, it is possible to supply this +5V-Bus
from the +5V of the Autobot.
The +5V-jumper J3 must be set.
The +5V supply of the Autobot can be loaded up to 200mA.
Please do not set the jumper J3, if there is no modul in the need of the +5V-
supply.