Panasonic OMNIVISION PV-8661 - Manual (Page 15)

On-Screei^Dis£lay^(OSB^
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
(Some Station names may
also appear if Channel
Caption is set. See page 20.)
Menu Screen
1 Press ACTION to
display the menu.
2 Press AT and ► to
make your selection.
SET UP VCR
SET UP FEATURE
SET UP CHANNEL
ID I ОМА/ LANGUE: ENGL I SH
SELECT;*. T KEY
SET :► KEY
END ;ACT ION KEY
To get the most from each feature,
please read the Operating Manual
before attempting any operation.
VCR Status & Clock Display
Press DISPLAY to display or remove the
overlay shown below.
Function
Status
Current Time
Channel Caption
(See page 20.)
Ree Time
Remaining
(OTR mode only
see page 17.
00AM ABC
0:25 -0:12:34
»STEREO SP
»SAP
MONO .4
Broadcast Audio
Being Received
(See page 26.)
• This display will
disappear in 5 seconds.
Counter
Tape Speed
(See page 5.)
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in
Play mode, or when the selected channel has no
broadcast signal with the Blue Back ON/OFF
Feature (page 21) set to ON, the TV screen will
turn solid blue.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 12.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 18.)
PLEASE SET CLOCK
BEFORE PROGRAMMING
After a Timer Program has
been set...
(See page 18.)
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
If you press REC on the
CHECK CASSETTE remote control or VCR,
and a cassette is inserted
with no record tab...
RECORD TAB
(See page 17.)
if you press PLAY, FF, REW,
NO CASSETTE
or REC on the remote
control or VCR without
a cassette inserted...
PLEASE INSERT A CASSETTE
(See pages 16,17.)
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only)
(See page 19.)
TO CANCa TIMER REC
PUSH POWER THEN STOP KEY
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
If you press a function button
other than STOP/EJECT or
POWER on the VCR, or STOP
or EJECT or POWER on the
remote control while the VCR is
in VCR Lock mode...
(See page 22.)
VCR LOCK ACTIVATED
If you press POWER, ACTION
or PROG on the remote while
in TV or CABLE/DSS mode...
(See pages 32,33.)
NOW TV/CABLE/DSS MODE
PLEASE PUSH VCR KEY
ON REMOTE
15