Panasonic NV-G45 Series - Manual (Page 25)

DUBBING (COPYING)
Dubbing (copying) from one video cassette to another.
AUDIO IN VIDEO IN
Preparation
•Press the VTR On/Off Switches to turn both VTRs on.
•Make the necessary connections as shown in the connec­
tion diagram.
•Make sure that the Edit Switches of both the recording
and playback VTRs (if equipped) are in the “On” position.
Set these switches to "Off” for ordinary use of the VTRs.
(The Edit Switch is on the front panel.)
O Place the recorded cassette in the playback VTR and a
blank video cassette with the erasure prevention tab
intact in the recording VTR.
e
Press the Record Button (•) on the recording VTR.
© Press the Play Button {►) on the playback VTR.
© Press the Stop Button (■) on both VTRs to stop the
dubbing.
/'-------------------------------------------------------------------------------
•To assure smooth, noiseless cuts when interrupting
the recording, always use the Pause/Still Button
(II)-
•To obtain smooth cuts when starting the recording
from the stop mode:
1. Play back the last part of the previously recorded
material to confirm its ending point, and then
press the Pause/Still Button
(II).
2. Press the Record Button (•).
(The VTR is still in the pause mode.)
3. To start recording, press the Pause/Still Button
(II) again.
•The picture quality of a re-recorded tape is not as
good as that of the original.
•Disconnect all cables from the Video Input and
Audio Input sockets after finishing the recording. If
they remain connectd, it is impossible to record TV
programmes._________________________________
Connecting to a VHS/VHS-C Movie Equipped with
Synchro Edit Function
It is possible to synchronize the playback start and stop of
the VHS/VHS-C Movie with the recording start and stop of
this VTR.
To Remote Control Socket
Synchro Connection Cord
(VW-K1)
(Optional)
For the connection of the AV-
cord, refer to the operating
instructions of the VHS/VHS-C
Movie.
AUDIO IN VIDEO IN
Synchro Edit Socket
Preparation
•Make the necessary connections as shown in the connec­
tion diagram.
•Set the Edit Switch on both the VHS/VHS-C Movie and on
this VTR to "ON”.
O Put this VTR in the recording pause mode.
© Put the VHS/VHS-C Movie in the still playback mode.
•Put the Movie at the point where you want to start
editing into the still playback mode.
© Press the Pause/Still Button on the VTR.
•The VHS/VHS-C Movie changes over to the playback
mode and the editing will start automatically.
To Leave out Unwanted Scenes
(T) Press the Pause/Still Button on the VTR.
•The VTR changes over to the recording pause mode
and the VHS/VHS-C Movie changes over to the still
playback mode.
(2) Operate the VHS/VHS-C Movie to skip the unwanted
scenes and then put it in the still playback mode again.
Press the Pause/Still Button on the VTR.
•The editing will be restarted.
To stop the editing, press the Stop Button on the VTR and
then put the VHS/VHS-C Movie in the stop mode.
25