Panasonic CY-V7100U - Manual (Page 29)

and checking the remaining exposed wires from the cut
radio connector piug.
if your car is not wired for an audio unit:
Go to the fuse biock and find the fuse port for the battery,
usuaiiy marked BAT.
□ Connect All Leads
Now that you have identified aii the wires in the car, you're
ready to begin connecting them to the LCD monitor wires.
The wiring diagram (**■ page 36-38) shows the proper
connections and coior coding of the ieads.
We strongiy recommend that you test the unit before mak­
ing a finai instaiiation.
You can set the unit on the fioor and make temporary con­
nections to test the unit. Use eiectricai tape to cover aii
exposed wires.
I Caution: Connect the red oo’.vei iead Iasi, after you
illiiBIliiifciiiMiiBili®
Ground
Connect the biack ground iead of the power connector to
the metai car chassis.
Battery
Connect the yeiiow battery iead to the correct radio wire or
to the battery fuse port on the fuse block.
Equipment
Connect any optional equipment according to the instruc­
tions furnished with the equipment. Read the operating and
installation instructions of any equipment you will connect
to this unit.
Power
Connect the red power lead to the correct car radio wire or
to the appropriate fuse port on the fuse block.
If the LCD monitor functions properly with all these con­
nections made, disconnect the wires and proceed to the
final installation.
□ Final Installation
Lead Connections
Connect all wires, making sure that each connection is
insulated and secure. Bundle all loose wires and fasten
them with tape so they will not fall down later. Now insert
the LCD monitor into the mounting plate.
Congratulations! After making a few final checks, you’re
ready to enjoy your new LCD monitor.
□ Final Checks
1. Make sure that all wires are properly connected and
insulated.
2. Make sure that the LCD monitor is securely held in
the mounting plate.
3. Turn on the ignition to check the unit for proper
operation.
If you have difficulties, consult your nearest authorized
professional installer for assistance.
□ Precautions
Cautions:
» Wa strongly recommend that you wear gloves for
instaiiation work to protect yourseif from injuries
♦ When bending the mounting tab of the mounting
coiiar with a screwdriver, be careful not to injure
your hands and fingers.
________________________________
• Disconnect the cable from the negative (-) battery termi­
nal (see caution at right).
Caution: Various settings that have been stored in the
rnernor/ in other on-boait! equipment (car navigation
etc.) may be lost it the batter/ terminals are disconnected.
Therefore, v/e recommend making a record of or to back
up the settings before disconnecting the terminals.
After compieting mstaitelion of tire main unit, set the
equipment again according to the record
This unit shouid be professionaiiy instaiied. In case of
difficulty, please consult with your nearest professional
installer.
1. This unit only operates in a 12 V DC negative ground
system.
2. Follow the electrical connections carefully (*# page 36-
38). Failure to do so may result in damage to the unit.
3. Connect the power lead after all other connections are
made.
4. Be sure to connect the battery lead (yellow) to the posi­
tive terminal (+) of the battery or fuse block (BAT) termi­
nal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before connect­
ing it to this unit.
i Caution: Please follow mu laws aod reguiations of
I your state, province or countrv-ior installation of the
CY-V7100U
2 9