General, Power, Mode – Panasonic CY-V7100U User Manual
Page 21: Wofliiie, Tift angle, Only for wired headphones)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General
Power
Turn your car's ignition key to ACC or ON position.
ON:
press
[MODE] (POWER)
on the display unit.
Press [PWR] (Power) on the remote control.
OFF:
press
[MODE] (POWER)
again for more than
2 seconds on the display unit.
Press [PWR] (Power) again on the remote control.
Mode
I
Press [MODE] to change the mode.
■ ■
i—►
” ” -rPt
Note:
If VTR 1 is selected in “Video Control Setting” on
page 22 on the condition that an external device is con
nected to the VTR 1 terminal of this unit and the video
control leads from both this unit and the device are con
nected to each other, the VTR 1 mode becomes active
immediately after turning on the power of the external
device.
[VOL V]
[VOL
A]
[MODE]
(POWER)
Audio Output Terminal for Wired Headphones
[PWR] (Power)
[MODE]
Wofliiie
(Only for wired
headphones)
[VOL A]: up
[VOL V]: down
Default: 20
Setting Range: 0 - 30
VOL 22 iilliililillii»
Note:
The volume is not adjustable during Video Control
Setting, IR-OUT Setting, and Display Setting. (*# page
22-25)
Tift Angle
Push the upper part or lower part of the monitor gently
with both hands as shown in the figure.
: Caution:
Do rsot apply excespr.-t force lo the iTionvor
• Be careful om ts c.iiseeae your Tngerr,
:
if.: xjn ip i:
yC::-1:0 v::
h
l;':- f cf te c ft:.- tv: :!• y''-/
Note:
After adjusting its angle, also adjust the brightness
according to your preference. (# page 24)
J
_____[VOL
A]
[VOL
V]
CY-V7100U
2 1