Panasonic WV-CB700A - Manual (Page 10)

135. Item Switch (ITEM)
This switch is used to choose the item in the set-up
menus.
136. Page Switch (PAGE)
This switch is used to choose the desired set-up
menu from the four menus,
137. Subcarrier Phase Coarse and Fine Controls
(SC PHASE COARSE/FINE)
These controls allow for adjustment of the camera
signal subcarrier phase from 0° to 360°, to match
the phase with that of the burst signal at the
Gen-lock Input Connector on the RCU in a system
configuration.
The COARSE control adjusts the subcarrier phase
from 0° to 360° in 90° steps, while the FINE control
allows for continuous fine adjustment over a range
of 90°
139. ENC/VF Selection Switch (ENC/VF, OFF/ON)
This switch selects Encoder output or EVF (black
and white) output from the Video Output Connector
and whether the User Set Function is available as
follows:
1. Switch set to position #1:
Encoder is output from
Connector on the RCB
function is not available.
2. Switch set to position #2:
Encoder is output from
Connector on the RCB
function is available,
3. Switch set to position #3;
EVF (black and white) signal is output from the
Video Output Connector on the RCB, User Set
function is available and the User Set menu is
displayed on the monitor.
the
and
the
and
Video Output
the User Set
Video Output
the User Set
138, Horizontal Phase Control for Gen-lock
(H PHASE)
The horizontal phase of the camera signal can be
adjusted to match the horizontal phase of the signal
at the Gen-lock Input Connector on the RCU.
- 8 -