Losi LOSB0290 User Manual

Page 11

Note: Please read the entire manual to gain a full understanding of the 1/10 Slider
vehicle, fine-tuning the setup and performing maintenance.

 1. Read the safety precautions found on page 3. This is important for your safety and

prevention of personal injury.

 2. Charge the battery pack you have chosen (NOT INCLUDED). Refer to the

manufacturer’s supplied instructions for battery charging information.

 3. Install the AA batteries into the LSR-3000 transmitter (see page 9). Use alkaline or

rechargeable batteries only.

 4. Install the battery pack (see previous page). The battery pack should be fully charged

before installation.

 5. Turn on the transmitter and then the vehicle. It is a good practice to

turn on the transmitter before the vehicle and turn it off after the vehicle has
been turned off.

 6. Check steering (see page 12). Verify that the servo is functioning properly.

 7. Driving the 1/10 Slider (see page 14).

 8. Performing maintenance of the 1/10 Slider. Refer to Tuning, Adjusting and

Maintenance of the 1/10 Slider on page 15.

Quick Start