Losi LOSB0222BD Getting Started - Manual (Page 2)

MRC V
Page 2
Always turn on the transmitter first by sliding the
switch on the left side of the wheel from left to right.
The small red and green lights above the switch should
both light up. If not, you need to check for low or
incorrectly installed batteries.
Step 6
Although set at the factory, below are the steps required
to re-bind your transmitter to the receiver should the need
arise. During the bind process there is a unique ID from
the transmitter communicated to the receiver to ensure
trouble-free radio operation.
Steps to Re-Bind
. Ensure that the transmitter and vehicle are both turned
off.
2. Using the supplied Bind plug (which looks like a
standard receiver plug with a wire loop installed) insert
or plug into the receiver slot labeled “BIND.” Looking
down on the receiver, this slot would be below the
LED and is the farthest from the LED, or nearest to the
corner of the receiver.
Note: You do not need to remove any of the other
plugs to re-bind.
3. With the Bind plug installed, turn on the vehicle. You
Will notice a blinking orange LED within the receiver.
4. Now you are ready to turn on the transmitter. You
should notice on the back of the transmitter a similar
blinking orange LED under the translucent cover.
5. Both the receiver and transmitter blinking orange LEDs
will stop blinking and become solid, indicating they
have “bound” themselves together.
6. Please turn off both the vehicle and transmitter to
remove the Bind plug from the receiver. Failing to
remove the Bind plug will cause the transmitter to
attempt to rebind every time you turn on the vehicle
and transmitter.
7. Turn on both the vehicle and transmitter to ensure
operation. If the transmitter does not control the
vehicle, please repeat steps to 6. Should this not
correct the problem, please call Horizon Service/Repair
for further assistance.
8. The Bind process is complete. Your vehicle’s radio
system should be ready for use.
Step 7
Once the transmitter has been turned on, turn on the Mini-
Rock Crawler by sliding the switch on the speed controller
to the “On” position. If the rear wheels turn, adjust the “TH.
Trim” knob located to the lower right of the steering wheel
until they stop. To go forward, pull the trigger back. If you
should need reverse, wait for the model to stop then push
the trigger forward. When going forward the model should
move in a straight line. If not, adjust the “ST. TRIM” so that it
tracks in a straight line without having to turn the steering
wheel. After you are finished, turn the Mini-Rock Crawler
off FIRST by sliding the switch to the “OFF” position. After
the model has been turned off, turn off the transmitter. If
you wish to clean your Mini-Rock Crawler, use compressed
air and/or a soft paintbrush to remove dust and dirt. NEVER
use chemicals or anything wet as that can cause damage to
both electronics and plastic parts.
aLWaYS
• Turn on the transmitter before the vehicle
• Use caution when running your vehicle near people
• Turn both the Mini-Rock Crawler and transmitter “Off” when done
• Check the battery condition of the transmitter before running
neVer
• Operate the Mini-Rock Crawler with low battery power
• Run the Mini-Rock Crawler through water or wet grass
• Use chemicals to clean the chassis
• Run the Mini-Rock Crawler without a gear cover
Step 5 Step 6
St. Trim
Off/On
Right Left
Th.Trim
Forward
Brake/Reverse