Losi LOSB0222BD Getting Started - Manual

Page
GettinG Started
Step 1
Plug the AC charger into the proper wall receptacle
(0V). Plug the battery pack into the charger and
let it charge for 3 hours for the first time. After
running, or when the Mini-Rock Crawler slows
noticeably, recharge the battery pack for 5 to 6
hours for a full charge.
Step 2
Remove the transmitter battery cover by sliding the
cover from left to right. Install four (4) AA batteries
into the battery holder. Pay close attention to the
correct direction of the positive (+) and negative (-)
ends as marked in the tray. Once all 4 batteries have
been installed, reinstall the battery cover by sliding it
on from right to left.
Step 3
Once the battery is charged, remove the body clips
from the battery hold-down and remove the battery
strap (fig. ).
Install the charged battery pack into the chassis as
shown (fig.2). Ensure that the battery is laying flat on
the chassis.
nOte:
Before you start running your new Mini-Rock Crawler, it is absolutely
necessary that you read through all of the operating instructions to prevent
unnecessary damage and get the maximum enjoyment from your vehicle.
Reinstall the battery strap and body clips. Plug
the battery pack into the ESC (fig. 3).
Step 5
TM