BoonDocker ARCTIC CAT: Non-turbo Control Box 800/1000 Operation (New) - Manual

BoonDocker – 2379 Heyrend Way, Idaho Falls, ID 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381 Page 1 of 5
13 RPM Control Box Instructions with A/F input
For Arctic Cat and Polaris
Carefully read the descriptions below of each new feature before using the Control Box:
1. RPM Modes (13 RPM / 5 RPM)
The Control Box can be used in either 13 RPM Mode, or 5 RPM Mode. See 4. Setup Menu below about
how to change between these two modes.
1a. 13 RPM Mode
13 RPM screens with 6 TPS settings are available in the Fuel Menu as shown below. TPS settings are
shown as 1-6 after “00”, Left/Right arrows will move cursor over each number and Up/Down buttons
adjust each fuel setting.
Note: When the Arrow is over the RPM, use the Up / Down buttons to change RPM settings. Use
Left/Right buttons to go to TPS setting 1-6, then use Up/Down to change the setting.
TPS position 1 corresponds to the lowest throttle position setting and 6 corresponds to the highest
throttle position. See 4. Setup Menu about how to change the default TPS transition values.
Each TPS position will be displayed in the Stats screen as: L1, L2, M3, M4, H5, H6 (L=Low, M=Mid, H=High).
1b. 5 RPM Mode
5 RPM screens with 3 TPS settings are available in the Fuel Menu as shown below.
LO = low load range= tps 1
MD = mid load range = tps 3
HI = high load range = tps 5
The Control Box always uses 13 RPM and 6 TPS settings to make fuel adjustments. The 5 RPM Mode is used for
making broad adjustments to multiple RPM and TPS settings at once. The 5 RPM Mode only shows every third
RPM setting (rpm1,4,7,10,13) and every other TPS setting (tps1,3,5). Whenever a Fuel setting is changed, up to 5
additional fuel settings are also changed at the same time. Below is an example (the result of each example is
shown color-coded in the table below):
Example 1: 2500 LO is incremented by 1. The
following settings will be incremented by 1:
2500 *tps1, tps2
4000 tps1, tps2
Example 2: 6750 MD is decremented by 1. The
following settings will be decremented by 1:
6500 tps3, tps4
6750 *tps3, tps4
7000 tps3, tps4
Useful Tip1: Press the Left + Right Arrow Buttons together at any time to return to the Main Menu
Useful Tip2: Press the Sel + Right Arrow Buttons together at any time to go to 5rpm Fuel Menu
Useful Tip3: Press the Sel + Left Arrow Buttons together at any time to go to 13rpm Fuel Menu
M1U
↓
00
1
00
2
00
3
2500 00 4 00 5 00 6
M1U↓ LO MD HI
2500 00 00 00