Craftsman 917.275013 - Manual (Page 24)

TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years
of service. The clutch has a built-in brake
that stops the pulley within 5 seconds.
Eventuaily, the internal brake will wear
which may cause the mower blades to
not engage, or, to not stop as required.
Adjustments should be made by a Sears
or other qualified service center.
1. Make sure attachment ciutch and
ignition switches are in “OFF” position.
2. Adjust the three nylon locknuts until
space between clutch plate and rotor
measures .012" at all three slot
locations cut in the side of brake plate.
NOTE: After installing a new electric
ciutch, run tractor at fuii throttle and
engage and disengage electric ciutch 10
cycles to wear in clutch plate.
___Rotor ._.
With Parking Brake “Engaged”
NylonP^ Slot (3)-
Clutch Plate .
012
"
Locknut (3)
Brake
Plate
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the ieft
side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in highest
gear on a ievei dry concrete or paved
surface, then brake must be adjusted.
1. Depress clutch/brake pedal and
engage parking brake.
2. Measure distance between brake
operating arm and nut “A” on brake rod.
3. If distance is other than 1-3/4", loosen
jam nut and turn nut “A” until distance
becomes 1-3/4". Retighten jam nut
against nut “A”.
4. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact a Sears or other qualified
service center.
TO REPLACE MOTION DRIVE BELT
Park the tractor on ievei surface. Engage
parking brake. For ease of sen/ice there
is a beit installation guide decal on
bottom of left footrest. It is not necessary
to remove mower.
BELT REMOVAL-
1. Engage parking brake (creates slack
in belt).
2. Remove mower drive belt from electric
clutch pulley only (See “TO REPLACE
MOWER DRIVE BELT in this section
of this manual).
3. Roll motion drive belt off transaxle
pulley.
4. Roll belt off clutching idler pulleys,
then off engine pulley and front V-idler
pulley.
5. Pull belt out of all belt keepers.
BELT INSTALLATION -
1. Place V part of belt into grooves on
engine puiley and front V-idler,
making sure to route beit inside of belt
keepers.
2. Put belt coming from V-idier above
midspan belt keeper, then onto
clutching idler pulleys as shown.
3. Make sure V part of belt engages V-
idler.
4. Place belt around transaxle pulley,
beginning at top.
V part of belt should engage transaxle
pulley.
5. Place long lower section of belt
through loop in midspan belt keeper.
6. Check to be sure belt is on proper
side of ali belt keepers.
7. Reinstall mower drive beit onto
electric clutch pulley.
IMPORTANT: Check Brake Adjustment.
24