Craftsman 917.28914 - Manual (Page 7)

Keys
(2) Keys
Slope Sheet
ASSEMBLY/PRE-OPERATION
ADJUST SEAT
Your new tractor has been assembled at the factory with exception of those parts
unassembled for shipping purposes.
C Onni llOCn cno AOCCft/iQI V
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2“ wrench Tire pressure gauge
(2) 7/16“ wrenches Utility knife
Pliers
When right or left hand is mentioned in this
manual, it means when you are in the operating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts cartons from carton .
• Cut along dotted lines on ail four pan­
els of carton. Remove end panels and
lay side panels flat.
• Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
TO CHECK BATTERY
1. Lift hood to raised position,
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
• For battery and battery cable installation
see “REPLACING BATTERY" in the
"Service and Adjustments“ section in
this manual.
left
1.
2,
3.
Sit in seat.
Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press ciutch/brake
pedal all the way down.
Release lever to lock seat in position.