Craftsman 917.28914 - Manual (Page 13)

Your tractor is equipped with a Reverse
Operation System (ROS), Any attempt by
the operator to travel in the reverse direction
with the attachment clutch engaged will shut
off the engine unless ignition key is placed
in the ROS "ON" position,
A war NING: Backing up with the at­
tachment clutch engaged while mowing is
strongly discouraged. Turning the ROS "ON",
to allow reverse operation with the attach­
ment clutch engaged, should only be done
when the operator decides it is necessary to
reposition the machine with the attachment
engaged. Do not mow in reverse unless ^
absolutely necessary.
USING THE REVERSE OPERATION 2
SYSTEM -
Only use if you are certain no children or other
bystanders will enter the mowing area, '
T, ‘ ‘
REVERSE OPERATION SYSTEM (ROS)
turn ignition key
ROS "ON" posi-
Move motion control lever to neutral
position.
With engine running
counterclockwise to
tion.
Look down and behind before and while
backing.
Slowly move motion control lever to
reverse (R) position to start movement.
When use of the ROS is no longer needed,
turn the ignition key clockwise to engine
"ON" position.
ROS "ON" Position Engine "ON" Position
{Normal Operating)
ITJUTtl
TO OPERATE ON HILLS
A
w ARNING; D o not drive up or down
hills with slopes greater than 15° and do not
drive across any slope. Use the slope guide
provided at the back of this manual,
• Choose the slowest speed before starting
up or down hills,
• Avoid stopping or changing speed on
hills.
• If stopping is absolutely necessary, push
clutch/brake pedal quickly to brake position
and engage parking brake.
• Move motion control lever to neutral posi­
tion.
IMPORTANT: The motion control lever does
not return to neutral position when the clutch/
brake pedal is depressed,
• To restart movement, slowly release park­
ing brake and clutch/brake pedal.
" Slowly move motion control lever to slow­
est setting,
• Make all turns slowly,
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by placing
freewheel control In freewheeling position.
Freewheel control is located at the rear
drawbar of tractor.
Raise attachment lift lever to its highest
position.
Puli freewheel control out and into the slot
and release so it is held in the disengaged
position.
Do not push or tow tractor at more than
two (2) MPH.
To re-engage transmission, reverse above
procedure.
TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED_____
NOTE: To protect hood from damage when
transporting your tractor on a truck or a trailer,
be sure hood is closed and secured to tractor.
Use an appropriate means of tying hood to
tractor (rope, cord, etc.).
TOWING CARTS AND OTHER ATTACH­
MENTS
Tow only the attachments that are recom­
mended by and comply with specifications
of the manufacturer of your tractor. Use
common sense when towing. Too heavy of
a load, while on a slope, is dangerous. Tires
can lose traction with the ground and cause
you to lose control of your tractor.
13