Assembly, Carton contents, Installing brushcutter attachment – Craftsman C944.511591 User Manual
Page 5: Handlebar assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
CARTON CONTENTS
Check carton contents against the fol
lowing list.
Model C944.511591
• Brushcutter attachment
• Handlebar
• Handlebar mounting bracket for 1''
{2.5 cm) shaft
• Handlebar mounting bracket for 7/8"
{2.2 cm) shaft
• Bracket cover (2)
• Shoulder strap
• Upper shoulder strap clamp
• Lower shoulder strap clamp (with
spacer tabs)
• Handlebar bracket screws (4)
• Shoulder strap clamp screws (2)
• Attachment Hanger
• Hex Wrench
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find
that parts are missing or damaged, con
tact your Sears Service Centre.
ASSEMBLY
^WARNING:
If received assembled,
repeat all steps to ensure your unit is
properly assembled and all fasteners
are secure.
• A hex wrench (provided) is required
for assembly.
INSTALLING BRUSHCUTTER AT
TACHMENT
CAUTION: When removing or instal
ling attachments, place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Coupler
.OOSEN
Remove the shaft cap from the
brushcutter attachment (if present).
Position locking/release button of
attachment into guide recess of
coupler.
Push the attachment into the cou
pler until the locking/release button
snaps into the primary hole.
5. Before using the unit, tighten the
knob securely by turning clock
wise.
Coupler
Uooer
Locking/
Release
Button
Aft WARNING;
Make sure the lock
ing/release button is locked in the pri
mary hole and the knob is securely
tightened before operating the unit.
HANDLEBAR ASSEMBLY
A
DANGER:
risk
of
cut
. T
o
avoid
serious injury, the barrier portion of the
handlebar must be installed as shown
on the upper shaft of the powerhead to
provide a barrier between operator and
the spinning blade. Attach handlebar
mounting bracket above arrow on
safety warning decal on the upper
shaft (powerhead end of unit).
Ensure handlebar is positioned on
mounting bracket at the end of the ar
row on the handlebar decal.
NOTE: Two mounting brackets are in
cluded with this attachment. Both brack
ets are provided to adapt this attach
ment for use with powerheads that have
either a 1" (2.5 cm) diameter or a 7/8"
(2.2 cm) diameter upper shaft. The cor
rect bracket must be used to ensure that
the handlebar is mounted securely to
the upper shaft before use.
Place the mounting bracket over
the upper shaft above the arrow on
the safety label. Be sure to use
the correct mounting bracket for
either the 1" (2.5 cm) or 7/8” (2.2
cm) diameter upper shaft.