Craftsman 172.74815 - Manual (Page 6)

SAFETY INSTRUCTIONS cont.
SAFETY RULES FOR BATTERY CHARGING STAND cont.
10. Do not disassemble charging stand.Take it to a Sears Parts and Repair Center
when service or repair is required. Incorrect reassembly may result In a risk of
electric shock or fire.
11. Disconnect charging stand from the power supply when not in use. This will
reduce the risk of electric shock or damage if metal items should fall into the opening
in the charging stand. It also will help prevent damage during a power surge.
12. Risk of electric shock. Do not touch un-insulated portion of output connector or
un-insulated battery terminal.
13. Save these instructions. Refer to them frequently and use them to instruct
others who may use this tool. If you loan someone this tool, also loan them these
instructions to prevent misuse of the product and possible injury.
ADDITIONAL RULES FOR SAFE OPERATION
A WARNING: BE sure to read and understand aii instructions. Failure to
follow all instructions listed below may result in electric shock, fire and / or
serious personal injury.
1. ALWAYS wear safety glasses or eye shields when using this tool. Everyday
eyeglasses have only impact-resistant lenses; they are NOT safety glasses.
2. PROTECT your lungs. Wear a face mask, dust mask or respirator if the operation is dusty.
3. PROTECT your hearing. Wear appropriate personal hearing protection during use.
Under some conditions noise from this product may contribute to hearing loss.
4. ALL VISITORS AND BYSTANDERS MUST wear the same safety equipment that the
operator of the tool wears.
5. ALWAYS check the tool for damaged parts. Before further use of the tool, a guard
or other part that is damaged should be carefully checked to determine if it will operate
properly and perform its intended function. Check for misalignment or binding of moving
parts, breakage of parts, and any other condition that may affect the tool’s operation.
A guard or other part that is damaged should be properly repaired or replaced
at a Sears Service center.
6
.
SAVE THESE INSTRUCTIONS.
Refer to them frequently and use
them to instruct others who may use this tool. If someone borrows this tool,
make sure they have these instructions also.
1 0
UNPACKING (Fig: 1)
1. The trimmer comes assembled except for the guard and auxiliary handle,
which must be attached.
2. Remove the trimmer, auxiliary handle, safety guard, box containing the battery pack
and charger, wall mount bracket for charger and wall mount bracket for trimmer with
hardware from the carton and inspect your trimmer.
3. Do not discard box or packing material until all parts are examined.
11