Wall, Sure, Power – Craftsman 172.74815 User Manual

Page 14: Operate, Stand

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION coni.

A CAUTION:

Before you begin trimming, oniy use the appropriate type of

cutting line.

OPERATING TIPS

Before

each

use

make sure the protective safety guard is tightly installed. Tighten the

guard screw, but

DO NOT

over tighten.

2. Be sure to check the auxiliary handle before each use, to make sure it is firmly tightened.

Before trimming,

inspect the area for string, wire, branches, rocks, toys, or other objects

that could be entangled in or thrown by the cutting line.

4. Stand with the cutting head tipped down at an angle in front, guiding the trimmer in a

semi-circular motion around you.

5. Cut from left to right whenever possible. Cutting to the right improves the unit’s cutting

efficiency. Clippings are thrown away from the operator.

6. To produce a smoothly trimmed area, move the trimmer in and out of the area being cut

with constant speed and height.

7. Use only the tip of the cutting line to do the trimming, especially near walls and fences.

Trimming with the side of the cutting line may overload the motor, wear out the line faster,
and break the line more often.

DO NOT

rest the trimmer spool on the ground while you are trimming.

This will cause spool wear.

9. When cutting vegetation that is over 6 inches in height, work from top to bottom in small

increments to avoid premature line wear or engine drag.

10. If the trimmer is not cutting correctly, the auto feed may not be operating correctly,

or the spool may be empty. Remove the spool and identify the problem. See page 22,
AUTOMATIC

LINE FEED SYSTEM

and page 23,

REPLACE CUTTING LINE

and FILLING SPOOL WITH CUTTING LINE.

BRACKETS FOR CORDLESS TRIMMER,

CHARGING STAND AND BATTERY PACK (Figs. 21,22, 22a

and

23)

The 2 storage brackets are a convenient way to help keep your trimmer, charging stand
and battery pack organized, ready for use and stored up, out of the way in a dry place.

The trimmer’s storage bracket mounts to wall with 4 screws and the trimmer can attach to
bracket two different ways (See Fig. 21).

The charging stand’s bracket mounts with 4 screws also,

but mount

the

charging stand

and its power cord into the

bracket

before

screwing it down tight (See Figs. 22 and 22a).

NOTE: Before mounting

the

charging stand bracket to the

wall,

make

sure

the power cord has access to a

power

outlet.

A WARNING:

NEVER store your cordless trimmer, or ieave your trimmer

unattended, with the battery pack instalied.

WARNING:

Store your trimmer, charging stand and battery pack up and

away from children. Children MUST NOT

operate

the tool.

OPERATION cont.

BRACKETS FOR CORDLESS TRIMMER,
CHARGING STAND AND BATTERY PACK cont. (Figs. 21, 22, 22a

and

23)

The battery pack can be conveniently stored in the charging stand, but ALWAYS make sure
the charging stand is disconnected from the power supply when storing the battery pack

in the charging stand.

SEE PAGES

9,10,14 and 15 FOR IMPORTANT

BATTERY PACK INFORMATION.

NOTE: Tighten all mounting screws securely. Always check to make sure the
bracket is tight to the wall, securely in place, and does not move.

WARNING:

The battery charging

stand

and trimmers are heavy; make sure

the storage brackets are securely mounted to the wall. Failure to do so

can

result

in damage to trimmer, charging stand and battery pack and

can

cause

serious personal injury.