Craftsman 917.773423 - Manual (Page 5)

ASSEMBLY
Read these instmctions and this tnanual in its
entirety before you attempt to assemble or
opierate your new trimmer,
IMPORTANT; This trimmer is shipped
WITHOUT OIL OR GASOUNE in the engine.
Your new trimmer has been assetrtded at the
factory with the exception of those parts left
unassembled for shipping purposes. Al parts
such as nuts, washers, bolts, etc., necessary
to complete the assembly have been placed
in the parts bag. To ensue safe and proper
operation of your triemer, all parts and
hardware you assemble must be tightened
searety. Use the oorrect tools as necessary
to ensue proper tightness.
Loose Parts Packed Separately
20 oz.
Battle of oil
Trimmer Lines
(2)Sets
{0.155 dla mater
X 1S.7S Inches long)
TO REMOVETRIMMER FROM CARTON
1. Remove loose parts included with
trimmer.
2. Cut down two end comers of carton
and lay end panel down flat.
3. Remove all packing materials.
4. Roll trimmer out of carton and check
carton thoroughly for additional loose
parts.
HOWTO SET UPVOURTRIMMER
TO UNFOLD HANDLE
IMPORTANT: Unfold handle carefuly so as
not to pinch or damage control cables.
1. Loosen handle knob enough to allow
upper handle to be unfolded from the
shipping position.
2. Raise upper handle section into place
on lower handle and tighten handle
knob.
3. Remove handle padding holding
trimmer head control bar to upper
handle.
Your trimmer handle can be adjusted for
your trimming comfort. Refer to "ADJUST
HANDLE" in the Service and Adjustments
section of this manual.
Upper handle
Handle
knob
Lower
handle