Sony SLV-750HF - Manual (Page 13)

VCR Setup
1
Set the RF UNIT on the VCR's rear panel to CH 3 or
CH4.
If you made A/V connections, skip this step.
^ to whichever channel is not used in your area,
lif both are used, pick either channel.
Details are on page 55.
2 Switch on your cable box.
3 Preprogram the channels into the VCR.
Press MENU. Select TUNER PRESET.
P(NU
PMMlIt SCr/CH(Ck
set UP H(Nu Twin PAcser
set VCA Plus* CHANNClS
CLOCK set
tIHEft Set/CHECK
set UP MENU
A tuNEP PAESet
set VCA Piuso CHANNElS
CLOCK set
Select AUTO PRESET,
then press EXECUTE.
TUNEA PAESET CM3
NOAH/CATV • NOAM CATV
PAUTO PAESE r
MANUAL SET • AOO eaase
AFT • ON OFF
FINE TUNING
Details are on pages 19 and 20.
VCR Plus+ Channel Setup
1 Find the VCR Plus-«- Channel Listing in your program
guide. For details, see page 42.
2 For all channels that you want to record, set each
channel to the channel that your cable box uses for
its output (usually 2,3, or 4), as follows:
Press MENU.
Select SET VCR Plus-«-
CHANNELS.
MENU MENU
P fIMEA SET/C h EC k riMEA SET/C he C k
SET UP MENU SEI UP MENU ruNEA PAESFT TUNEA PAfSFT
SET VCA Plus* CHANNELS N SET VCA Plus* CHANNFiS
ClOC« SEI CLOCK SEI
Enter the program guide
channel, then the cable box
output channel.
Program listing guide channel
Set to the same _
cable box channel.
VCA Plus« CHANNCL Lt$T
OUlOE TV
2 fTl
i
17
28
43
6UI0E TV-
> 3
88 • 3
Push MENU to quit
Details are on page 43. Your cable box channel —'
S'
fi}
G>
g
a
s
To Watch the TV
1 Turn your VCR off, or press the VCR’s TV/VTR button
until the VTR indicator in the display window goes off.
2 Switch on your cable box.
3 Tune the TV to the cable box output channel
(usually 2,3, or 4).
4 Select the channel that you want to watch with your cable
box.
To Watch the VCR
1 Tune the TV to CH 3 or CH 4, (or to A/V input if you
PLAY.
made A/V connections.)
2 Insert a cassette and press l
Details are on page 28.
To Record A Program
1 Switch on the cable box.
2 Select the channel you wish to record on the cable box.
3 Press VCR Plus+ on the Remote Commander.
4 Enter the program’s PlusCode number.
5 Press ONCE, DAILY, or WEEKLY on the Remote
Commander.
6 Insert a blank cassette.
7 Press TIMER REC on the Remote Commander.
8 Leave the cable box on.
Details are on page 44.
Preparation
M3