Sony KV-27V45 - Manual (Page 30)

Operating a cable box or DBS receiver
If the remote control doesn't work
Programming the remote
You can program the supplied remote control
to operate a cable box or DBS receiver.
1 Press CODE SET.
2 Press DBS/CABLE (FUNCTION).
3 Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4 Press ENTER.
For more details on operating: the-
cable box or DBS receiver
Refer to the operating instructions that were
supplied with the equipment.
• First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips
• If more than one code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries the code numbers
may revert to the factory setting and must be reset.
Manufacturer code numbers
(cable box)
Manufacturer Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. I. 201, 202, 203, 204, 205, 206,
207,208,218
Oak 227, 228, 229
Panasonic 219, 220,221
Pioneer 214,215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212,213
Manufacturer code numbers
(DBS receiver)
Manufacturer Code
Sony
801 (preset code for
remote control)
General Electric
802
Hitachi 805
Hughes
804
Panasonic
803
RCA/PROSCAN 802, 808
Toshiba
806, 807
28