Cisco SFS 7008 - Manual (Page 62)

62
6. Activate the image on the node card(s) by enabling and disabling each node card. Do not reboot the
chassis as this will not result in the image being applied to the node card(s).
a.
Right-click a node card and select Properties.
b. Click the down radio button and select the Apply button.
Figure 4-8: Disable and Enable the Node Card(s)
c. Click the up radio button and select the Apply button.
7. View the new image on the node card(s) when the card comes back online:
a. Select View > Device Front View.
b. Right-click one of the cards and select Properties.
c.
Click the Inventory tab and view the version name in the Current Image Source field.
Figure 4-9: Upgraded Current Image