Winchester Repeating Arms 1200 (Historic Manual) User Manual
Page 3

TO ASSEMBLE TRIGGER GROUP TO RECEIVER
1. Be sure hammer is cocked in trigger group as
i I I ustrated.
2. Be sure that the slide arms are in the cut outs
on the bottom of the bolt assembly.
3. Assemble trigger group to the receiver by carefully
working the front end of the group into the slots
at the front end of receiver. Gently push rear end of
trigger group down into position. If the front end
of the trigger group is correctly positioned, this will
require little effort. DO NOT FORCE.
4. Insert trigger guard pin from right to left and
push in flush with side of receiver.
10
See also other documents in the category Winchester Repeating Arms Sports and recreation:
- 70 (36 pages)
- X3 Shotgun (44 pages)
- X Rifle (28 pages)
- X Pump (SXP) (36 pages)
- Wildcat (24 pages)
- Select (34 pages)
- 94 (Includes Take Down) (36 pages)
- 1885 Centerfire (36 pages)
- 1885 Creedmoor (13 pages)
- 1892 (24 pages)
- 1895 (32 pages)
- 1895 Saddle Ring Carbine (12 pages)
- 1895 Take Down (15 pages)
- 1885 Rimfire (21 pages)
- 1873 (19 pages)
- 101 (36 pages)
- SX-AR (Historic Manual) (32 pages)
- 70 (Historic Manual) (31 pages)
- 94 Top Tang Safety (Historic Manual) (32 pages)
- 9410 Top Tang Safety (Historic Manual) (44 pages)
- 9417 (Historic Manual) (29 pages)
- 9422 (Historic Manual) (30 pages)
- 1300 (Historic Manual) (34 pages)
- 94 Cross Bolt Safety (Historic Manual) (34 pages)
- 94 Pre 1992 (Historic Manual) (18 pages)
- 9410 Cross Bolt Safety (Historic Manual) (40 pages)
- 1886 (Historic Manual) (43 pages)
- 1886 Supplement (Historic Manual) (12 pages)
- 1400 (Historic Manual) (19 pages)
- 63 (Historic Manual) (23 pages)
- Super X2 (Historic Manual) (43 pages)
- Super X2 Sporting Supplement (Historic Manual) (8 pages)
- Super X2 Practical Supplement (Historic Manual) (4 pages)
- Super X2 Practical Supplement (Historic Manual) (8 pages)
- Supreme (Historic Manual) (35 pages)
- BOSS (Historic Manual) (15 pages)
- 52B (Historic Manual) (19 pages)