Unitec American Parking Equipment - Manual (Page 32)

Document Number: GC1001 28
Document Title: Unitec APE Gate and Gate Controller for Multi-Lane Applications Installation Guide
1. Using the toggle switch at the top of the CPU board, place the Wash
Select II in setup mode by moving the switch toward the back of the Wash
Select II case. (The CPU board is located on the inside right wall of the
Wash Select II case.)
2. On the WSII keypad, use the (3) key to scroll forward and the (1) key to
scroll back. Scroll through the main menu until the “Wash Interface” option
is displayed. Press the (*) key to enter.
3. Scroll through this menu until the “Barrier Gate” option is displayed, and
then press the (*) key to enter.
4. Press the (1) button to enable the option.
3.1.2 Tunnel Mode
Depending on the interface of your WSII to the tunnel controller, you may need to put
the WSII into “Attended Tunnel Mode”
When the Tunnel Mode is set to “Attended,” each customer will receive a receipt to
give to the attendant, who will then arm the appropriate wash. For an interface to a
Gate controller, you should either use Roll Over or Attended mode. Do not use Mode
1 - Unattended mode.
1. Using the toggle switch at the top of the CPU board, place the Wash
Select II in setup mode by moving the switch toward the back of the Wash
Select II case. (The CPU board is located on the inside right wall of the
Wash Select II case.)
2. On the WSII keypad, use the (3) key to scroll forward and the (1) key to
scroll back. Scroll through the main menu until the “Wash Interface” option
is displayed. Press the (*) key to enter.
3. Scroll through this menu until the “Tunnel Mode” option is displayed, and
then press the (*) key to enter.
4. Press the (2) button for “Attended Tunnel Mode” or (0) button to disable
tunnel mode and then press the (*) key.