Setting network products, View or change network settings, Set or change web server login password – Pantum P2500W User Manual
Page 35: Restore to factory settings, Setting network products -4, View or change network settings -4, Set or change web server login password -4, Restore to factory settings -4
4-4
4.3. Setting Network Products
4.3.1. View or Change Network Settings
You can use the embedded Web server to view or change IP settings.
1. Long press the "Cancel/Continue" button on the control panel to print DEMO information
page, and view the IP address of the printer. DEMO page can be printed by long pressing the
button on the control panel (as shown in the figure below) in the idle status.
2. Type the IP address in the Web browser's address bar to access the embedded Web
server.
3. Click Settings tab to obtain network information. Change the settings as needed.
4.3.2. Set or Change Web Server Login Password
Use the embedded Web server to set a network password or change the existing password.
1. To open the embedded Web server, please log in first.
2. Click Administrator Settings tab.
3. Type the new password in the Password box and Confirm Password box.
4. At the bottom of the window, click Apply button to save the settings.
4.3.3. Restore to Factory Settings
If you want to reset all parameter settings of the printer, you can restore to the factory settings
by long pressing "Cancel/Continue" button when the printer is powered off to power on it and
holding for 10 seconds until the printer enters Ready status to finish the resetting work.
Note:
• The default username is "admin", and the initial password is "000000".