K-array KN10S - Manual (Page 13)

13
rev.A
KN6 - KN10S
For best performance, the AC Cable voltage drop should not exceed 10% at 115V
and 5% at 230V.
The minimum electrical service amperage required by a K-array Skin system is
the sum of their maximum continuous RMS current. We recommend allowing an
additional 30% above the minimum amperage to prevent peak voltage drops at the
service entry.
140VA(>10 sec) - 700VA (<1 sec) autorange
KN6/KN10S max continuous apparent power (VA)
8.4 REAR PANEL
1
2
5
6
7
8
9
10
14
13
12
11
3
4
1. Power connector IN
2. Power connector OUT (max 15A)
3. Preset selector,
press one to change, 10 sec. to store
4. Audio INPUT
5. Parallel audio OUTPUT
6. Indicator of proper operating
7. Indicator of signal/clip INPUT
8. Indicator of temperature protection
9. Indicator of clip limiter
10. Audio Input level PAD
11,12, 13, 14 Preset in use