Hanns.G HP195 - Manual (Page 21)

User’s Manual
ERROR MESSAGE & POSSIBLE SOLUTIONS
ƒ
CABLE NOT CONNECTED:
1. Check that the signal-cable is properly connected, If the connector is loose, tighten the
connector’s screws.
2. Check the signal-cable’s connection pins for damage.
ƒ INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode, set the computer to display mode given
in the following table.
FACTORY PRESET TIMING TABLE:
MODE RESOLUTION
HORIZONTAL
FREQUENCY (KHz)
VERTICAL
FREQUENCY (Hz)
1 640x400 @70Hz 31.469 70.087
2 640x480 @60Hz 31.469 59.940
3 640x480 @70Hz 36.052 70.004
4 640x480 @67Hz 35.000 66.667
5 640x480 @72Hz 37.861 72.809
6 640x480 @75Hz 37.500 75.000
7 720x400 @70Hz 31.469 70.087
8 800x600 @56Hz 35.156 56.250
9 800x600 @60Hz 37.879 60.317
10 800x600 @72Hz 48.077 72.188
11 800x600 @75Hz 46.875 75.000
12 832x624 @75Hz 49.725 75.000
13 1024x768 @60Hz 48.363 60.004
14 1024x768 @70Hz 56.476 70.069
15 1024x768 @75Hz 60.023 75.029
16 1152x870 @75Hz 68.681 75.062
17 1152x864 @75Hz 67.500 75.000
18 1280x720 @60Hz 45.000 60.000
19 1280x960 @60Hz 60.000 60.000
20 1280x960 @75Hz 74.592 74.443
21 1280x768 @60Hz 47.776 59.870
22 1280x768 @75Hz 60.289 74.893
23 1280x1024 @60Hz 63.981 60.020
24 1360x768 @60Hz 47.712 60.015
25 1440x900 @60Hz 55.469 59.901
26 1440x900 @75Hz 70.635 74.984
21