AJA HDP2 - Manual (Page 11)

1
11 AJA HDP2 HD-SDI/SDI to DVI-D Video and Audio Converter
Color Space—Selects the Video Format. Choose from Auto, 4:2:2 YCbCr, 4:4:4 RGB or
4:4:4 YCbCr. Choosing “Auto” lets the HDP2 automatically select the format
based on the capabilities indicated by the attached monitor.
Deep Color—Selects how Deep Color is supported. Choose from Auto, On or Off.
Choosing “Auto” lets the HDP2 decide based on input. Choosing On turns on
support for Deep Color 30-bit video (24-bit also supported).
RGB Range—Selects the Input Video Color Range. Choose Auto to let the HDP2 decide,
or choose SMPTE or Full color range.
Scaling—Choose Auto to let the HDP2 choose based on the attached output device’s
capabilities, 1:1 for no scaling, or Scale, to let the HDP2 scale for the attached
monitor. Displaying 1:1 only works properly when it is possible to display the
entire unscaled raster. For example, it is not possible to display a 1920 x 1080
input on a 1600 x 1200 monitor. For optimal performance with 1:1 scaling, use a
1920 x 1200 (WUXGA) monitor.
SD Format—Choose Normal (standard picture aspect ratio) or Anamorphic; these
control how an SD picture appears on an HD monitor.
Standard—Raster choices available are: Auto (let the HDP2 decide based on input),
Native, WUXGA, 1080p, 1080i, 720p, 576p, or 480p.
Frame Rate—Choices are: Auto (let HDP2 decide), VESA, 24/23.98, 25, 30/29.97, 48/
47.95, 50, or 60/59.94.
HDMI/DVI—Choose Auto, HDMI, or DVI. Choosing “Auto” lets the HDP2 automatically
select the output mode based on the input video and the attached device's
capabilities.
Audio Tab Screen The selections on this screen configure the output audio.
Mini Config, Audio Tab Screen