AJA HD10C2 - Manual (Page 8)

HD10C2 Mini-Converter v1.0r2 www.aja.com 8
HD VGA MODE
For HD VGA mode use the supplied 15 pin D adapter and make the following DIP switch
settings:
• S1 = RGB (right)
• S7 = HD SYNC OFF (right)—Note: only certain monitors require no sync on video.
Internal Jumper
An internal jumper inside the HD10C2 case allows you to select between bi and tri level
sync. To set the jumper, remove the four phillips screws securing the case cover
(dipswitch side) and locate the jumper in the middle of the circuit board (see illustration
below). Placing the internal jumper "S2" in the "0" position provides tri-level sync on the
HD output; alternatively, placing it in the "1" position allows for bi-level sync on HD
output. SD output is always bi-level. Note: jumper S1 is not used.
0
1
S1 S2
0
1
S1 S2
S2 Set
For
Tri-level
Sync S2 Set
For
Bi-level
Sync