Spaulding Lighting Laredo LCC - Manual (Page 2)

STEP-V LAMPING
* Replace reflector (F).
* Engage the lamp to socket (S).
* To ensure proper contact, loosen the lamp
one turn then retighten.
METAL HALIDE - PULSE START OR HIGH PRESSURE SODIUM
FLUORESCENT
* Replace cover (H) making sure not to pinch wires.
* Insert fixture lead wires (Q) thru grommet (R).
* Loosen screw (G) and remove wire cover (H).
* Use pipe sealant before engaging conduit
FOR THROUGH WIRING USING CONDUIT
* Make the wire connections.
fittings to prevent water leakage.
* Remove hole plugs (N) for the conduit entry.
FIG. 6
FIG. 7
B
J
(Fig. 2)
(Fig. 3)
(Fig. 7)
H
R
Q
BLK
WHT
GRN
* Make sure that the lamp size is medium base and
type matches the ballast specifications.
* Replace reflector (F).
* Engage the lamp to socket (S) and
rotate clockwise to lock in place.
* Make sure that the lamp size and
type matches the ballast specifications.
F
S
FIG. 8
FIG. 9
F
S
CAUTION: This is a twist lock socket.
Do not force lamp into socket.
STEP-IV WIRING
INSTALLATION INSTRUCTIONS
LAREDO LCC LUMINAIRE
(Fig. 8)
(Fig. 9)
REPLACING LED RING
FIG. 10
Contact Hubbell Lighting technical services for replacement LED ring.
* Remove three LED ring screws and nuts (P). Remove LED ring and
secure new replacement LED ring with screws and nuts.
* Insert connector (Y) thru wireway hole (Z).
Connect connector (Y) to new LED ring.
CAUTION : Ensure proper pin and guide slot orientation and secure firmly.
* Loosen (4) screws (K) then remove LED assembly.
* CAUTION: Gently disconnect each LED ring (W)
and insert connector (Y) thru wireway hole (Z). (Fig. 4)
* Secure LED assembly to housing using (4) screws (K).
(Fig. 4)
(Fig. 4)
(Fig. 4)
(Fig. 10)
P
LED RING
Hubbell Lighting, Inc. Doc. Number: 93015006
A subsidiary of Hubbell Incorporated Revision: *
701 Millennium Blvd • Greenville, SC 29607
Phone: (864) 678-1000
PAGE 2 OF 8
PAGE 2 DE 8
PAGINA 2 DE 8