Landoll 173531 FRAME STABILIZER KIT - Manual (Page 2)

1-2 Brillion Farm Equipment F-694 Edition
Brillion, Wisconsin 54110 rev10-09-2012
4. Lock the machine in lifted/raised position with the
wings unfolded (the wing tips need to rest on the
ground).
a. Lock the “over the center” lift linkage in the up
position by placing pin P/N 9J437 1/2 X 6
CLEVIS PIN thru the holes provided in the lift
linkage. The pin needs to pass below the square
tubular link to assure that the machine will not fall
when the cylinder pin is removed in a later step
(See Figure 1-3).
b. Make sure all hydraulic pressure is neutralized.
Figure 1-3
5. Position a jack (ten ton capacity or greater) under the
rear portion of the hitch, just in front of the frame and
apply enough lifting force to relax the two (2) 1” pins
that secure the base end of the machine lift cylinder
and the upper turn buckle assembly used to level the
machine (the turn buckle may have to be adjusted to
relax both pins simultaneously).
a. Remove the keepers from the pins that secure
the top of the turn buckle and the machine lift
cylinder.
b. Locate the pins P/N 173535, PIN, 1 X 6-3/16 in
the hardware package and replace the pins
allowing equal amounts of the pin to protrude
from either side (See Figure 1-4).
Figure 1-4
photo 1
SQUARE TUBULAR LINK
1/2 X 6 CLEVIS PIN
W/ 5/32 HAIR PIN
TOGGLE LINK
photo 2
BRACE, FRAME LH
WELDMENT
1 X 6-3/16 PIN
5/8-11 X 6 HEX HEAD
CAP SCREW
PLATE,
4 BOLT
5/8-11 HEX
LOCK NUT