Lukas SC 250 M - Manual (Page 12)

12
6.2 Cutting
The blades must be positioned at a 90° angle to the object to be cut.
Higher cutting capacities can be achieved by cutting as close as possible to the blade’s pivot
point.
During cutting, the gap between the blade tips (in the transverse direction) must not be
exceed of 3 mm (0.12 in.), otherwise the blade is in danger of breaking.
CAUTION!
Avoid cutting particularly high-strength parts of the vehicle’s bodywork (e.g.
side-impact protection): this almost always damages the combi tool!
RIGHT
RIGHT
WRONG
WRONG
12
6
9
3
15°
15°
90°