Heater Craft G200X - Manual (Page 5)

NOTICE– The above are general instructions for an electric golf car hook-up.
NOTE– The power source for electric golf cars is generally comprised of six (6) rechargeable
lead acid batteries that are connected in series to provide DC (direct current) voltage. Using a
voltmeter, you can test the positive (+) voltages by connecting the negative (–) lead to the last
negative (–) terminal in series and the positive (+) lead to the positive (+) terminal selected on
the batteries.
CAUTION– Some manufacturers may have a computer that reads voltage draw. This connection
may need to be after the computer pick-up.
Golf Car Installation
Page 4
Testing and Completing Heater Installation
1. Install the 3 amp fuse into red lead (fan motor).
2. Operate the switch to ensure the fan motor is blowing.
3. After testing fan operation, install the fuse into yellow lead (heat element).
4. Operate the switch to ensure the fan motor is blowing and the heat element is operating.
5. After testing is complete, secure wire harness and leads as necessary.
If you have questions about this product and/or the proper installation of this product, please
contact our customer service department between the hours of 6:30 am - 4:30 pm (PST)
Monday through Thursday and Friday, 6:30 am through 2:30 pm (PST).
Heater Craft
6672 Boekel Road
Rathdrum, Idaho 83858
Phone: (208) 687-4400
Fax: (208) 687-9700
Email: [email protected]
www.heatercraft.com
Questions?