InnoMax Scape Hand Control - Manual (Page 8)

8
S-
Cape II MR Hand Control Operation Guide
The three step procedure below is required to program 1 hand control to operate 2 beds.
Before beginning, make certain the beds are plugged into a working grounded electrical
outlet.
STEP 1
On bed 1, press the learn button for 1
second and release. The bed will be
equipped with either a power down box
or J box (FIGURE 1).
STEP 2
Simultaneously press and hold the Pos 1
and the head massage on/off buttons. The
transmission indicator light will flash
slowly and then flash rapidly. Continue to
hold for 2 seconds and then release the
buttons (FIGURE 2).
STEP 3
Repeat Step 1 and Step 2 for bed 2.
One hand control is now programmed to
operate two beds.
FIGURE 1: Power down box and J box receiver units.
J BOX
POWER
DOWN BOX
LEARN
BUTTON
LEARN
BUTTON
NOTE: POWER
DOWN BOX IS
NOT MOUNTED
TO BED FRAME.
J BOX IS
MOUNTED TO
THE BOTTOM
SIDE OF THE
BED FRAME.
TRANSMISSION
INDICATOR LIGHT
FIGURE 2
HEAD MASSAGE
ON/OFF BUTTON
POS 1 BUTTON
S-CAPE II MR PROGRAMMING 1 hand control - 2 beds