Broan BEST IS241 - Manual (Page 7)

- 7 -
INSTALLATION OF GLASS
FRAME
1. Insert the glass gasket along the edges of
the glass.
2. Insert the glass, from the top to the bottom,
over the blower unit and secure it to the
blower by means of the three brackets and
the six screws (1/8x3/8”) which have been
supplied. The brackets must be fixed on the
side of the blower unit which has not got
controls.
Note that the blower unit must be slightly
elevated to allow the glass to fully seat on
blower bracket. Place a block of packins
foam under the blower unit to accomplish
this.
ATTENTION: Not to break the glass, it's of
much importance for the plastic gasket to
cover every part of glass frame and that the
glass is not directly in contact with metal.
Glass frame appliances are part of a
prestigious range of hand crafted cooker
hoods; due to the particular steps of
processing the glass is subjected to, the
glass body could present some deffects and
distortion.
Please be very carefull not to hit the glass
with any objects made of porcelain, metal,
glass or anything else that is very heavy.
GLASS
BLOWER UNIT
GLASS
GASKET
GLASS
BRACKET
SIDE GLASS
BRACKETS
CONNECT DUCTWORK
Three people are required to perform the
following operations.
1. Place the hood under the lower part of the
support frame and connect the duct to the
duct collar. Be sure the control side is
orientated properly.
2. Use 6" round metal duct to connect the
duct collar on the hood to the ductwork
above.
3. Use duct tape to make all joints secure and
air tight.
DUCT
6” DUCT
COLLAR
SCREWS
(1/8X3/8”)
FRONT
FRONT
(CONTROL
SIDE)