Baracoda Barcode Reader - Manual (Page 51)

DualRunners – Communication Protocol v1.3 - 51 -
Data Capture
for Workforce
in Motion
01 : mifare ultralight card
02 : mifare 1K card
03 : mifare 4K card
ETC. the complete list of card types codes is shown below }
For each read sector/page:
If Mifare Ultralight :
{1B : page number
4B : data}
If Mifare 1K or 4K :
{1B : sector number
1B : block number
16B : data}
If ISO15693 card from NXP or TI :
{1B : block number
4B : data}
If ISO15693 card from STMicroelectronics :
{1B : block number
1B : data}
Code ID 0x82
Description Write data into a TAG
Payload 7+ bytes:
2B : { protocol mask
the mask format is the same as the one used in command 0x02.
if 00 00 is given, then the default mask will be used (the one defined with
command 0x02) }
1B : { timeout
Timeout for the response.
if 00 is given, then the default timeout will be used (5s) }
1B : { card type
00 : try any supported card
01 : write in mifare ultralight cards
02 : write in mifare 1K cards
03 : write in mifare 4K cards
ETC. the complete list of card types codes is shown below }
1B : { start sector
Number of first sector/page to start writing at}
2B : { length (MAX = 256)
Number of bytes to write
/!\ whole sectors will be written. If the specified number of bytes does not
complete one sector, the remaining space will be erased. }
xB : { data }
Response 1 byte: { 1 = success }