Vehicle installation – Audiovox ONYX User Manual

Page 10

Vehicle Installation

Installing the Vent Mount:

1 Locate a vent with horizontal

louvers sturdy enough to hold your
PowerConnect Vehicle Dock and radio .

2 If the vent louvers in your vehicle

are recessed, you may need to use
the longer vent clamps with the Vent
Mount . If so, remove the shorter vent
clamps and install the longer ones
into the Vent Mount . Be sure to observe the orientation of the vent
clamps as shown .

3 Push the Vent Mount onto the vehicle vent as shown (1) until it

hooks on the rear of the vent louver (2) .

4 Rest the foot against the bottom of the vent (2), and adjust the

tilt of the Vent Mount by repositioning the foot to a different
adjustment hole (3) .

To remove the Vent Mount, push the mount into the vent . Then lift up until
disengaged from the rear of the vent louver, and remove the Vent Mount .

PUSH

Dash

Vent

Louver

Foot

Vent

Dash

HOOKED

TILT

ADJUSTMENT

HOLES

Slide Short Vent Clamps Out

Remove End Cap

Slide Extended Vent Clamps In

Replace End Cap

Extended Vent Clamps

Short Vent

Clamps