Pioneer HTP-SB300 - Manual (Page 37)

Additional information 06
37
En
English
Deutsch
Italiano
Español
Pyccкий
Français
Nederlands
Important information regarding
the HDMI connection
There are cases where you may not be able to
route HDMI signals through this system (this
depends on the HDMI equipped component
you are connecting-check with the
manufacturer for HDMI compatibility
information).
If you aren’t receiving HDMI signals properly
through this system (from your component),
please try the following configuration when
connecting up.
Configuration
1
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the system. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
No picture. • Depending in the output settings of the source component, it may be
outputting a video format that can’t be displayed. Change the output settings
of the source, or connect your source component directly to TV using the
component or composite video jacks.
• This system is HDCP-compatible. Check that the components you are
connecting are also HDCP-compatible. If they are not, please connect your
source component directly to TV using the component or composite video
jacks.
• Depending on the connected source component, it’s possible that it will not
work with this system (even if it is HDCP-compatible). In this case, connect your
source component directly to TV using the component or composite video
jacks.
• If video images do not appear on your TV or flat screen TV, try adjusting
the resolution, DeepColor or other setting for your component.
• To output signals in DeepColor, use an HDMI cable (High Speed HDMI
TM
Cable) to connect this system to a component or TV with the DeepColor
feature.
No sound, or sound
suddenly ceases. • If you’ve made separate connections for audio, make sure you have assigned
the analog/digital jack(s) to the corresponding HDMI input for the component.
• Check the audio output settings of the source component.
• Check that the Audio Parameter setting is set to
HDMI AMP/THRU (refer
to page 24).
• If the component is a DVI device, use a separate connection for the audio.
Symptom Remedy
Note
1 • If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
• Depending on the component, audio output may be limited to the number of channels available from the connected
display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
• If you want to switch the input source, you’ll have to switch functions on both the system and your display unit.
• Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the
display every time you switch input sources.
HTP-SB300_SVYXCN_En.book 37 ページ ２００９年１０月２３日 金曜日 午後１時５８分