Pioneer RMX-1000-M - Manual (Page 11)

11 En
English
Using the NUDGE function
The [NUDGE (+, –)] button can be used to fine-adjust the cycle and tim-
ing of the sound output from the X-PAD FX section.
Press the [+] or [–] side of the [NUDGE (+, –)] button.
— [+]: The cycle and timing of the sound output from the X-PAD
FX section are advanced. When pressed and held, the cycle and
timing of the sound are advanced continuously until the button is
released.
— [–]: The cycle and timing of the sound output from the X-PAD
FX section are delayed. When pressed and held, the cycle and
timing of the sound are delayed continuously until the button is
released.
Inputting the BPM manually
Tap the [TAP] button at least 2 times in rhythm with the
beat (in quarter notes) of the sound being played.
The average value of the interval at which the [TAP] button was tapped
by finger is set as the BPM.
! The BPM can be set manually by pressing the [NUDGE (+, –)] button
while pressing the [TAP] button.
! The BPM can be set in steps of 0.1 by pressing the [AUTO] button
while pressing the [TAP] button, then pressing the [NUDGE (+, –)]
button while pressing the [AUTO] and [TAP] buttons.
SCENE FX section
3
3 1 2
4 5
1 SCENE FX indicator
This lights when the effect is on. The color changes according to the
type of [SCENE FX] button.
2 SCENE FX control
This adjusts the selected SCENE FX effect.
3 SCENE FX buttons
These turn the SCENE FX effects on and off.
4 SUB PARAMETER 1 control
This adjusts SCENE FX sub parameter 1.
5 SUB PARAMETER 2 control
This adjusts SCENE FX sub parameter 2.
Using the SCENE FX function
1 Press one of the [SCENE FX] buttons.
Select the SCENE FX effect type.
The button that was pressed flashes.
! For details on the types of effects, see Types of SCENE FX effects on
page 15.
! When the selected [SCENE FX] button is pressed again, the effect
turns off.
2 Turn the [SCENE FX] control.
The selected effect is applied to the sound selected in the FX SOURCE
section.
— The strength of the effect increases when the control is turned
clockwise. The strength of the effect is maximum when the con-
trol is turned fully clockwise.
— The strength of the effect decreases when the control is turned
counterclockwise. When turned fully counterclockwise, the
original sound is output, with no effect applied.
3 Turn the [SUB PARAMETER 1] control.
This adjusts the strength of the selected effect’s sub parameter 1.
— The strength of the effect increases as the control is turned
clockwise from the center. The strength of the effect is maximum
when the control is turned fully clockwise.