HornBlasters Outlaw CX Series - Manual (Page 3)

2
Installing Your Train Horn Kit
Planning Your Installation
This is the most important step in your installation.
• Plan out the location of each component before starting your installation.
• Make sure you have enough airline and wire to install the system before beginning the installation.
• Make sure mounting locations are secure and void of debris.
• Try to keep the supply wire to the compressor as short as possible. Wires lose voltage over distance therefore shorter wires
will result in better performance.
• Mount your air source unit in a location that is as cool as possible and away from heat sources. This will make your
compressor run cooler and last longer.
• Your air source unit must be mounted upright with the compressor above the tank. Failure to mount the unit in this position
will allow any condensation buildup to drain back in to the compressor and harm its components, and also will disrupt the
compressor’s ability to cool.
• Teflon tape or a locking compound should be used on every fitting in your air system to prevent air leaks; unless a white or
red PTFE paste is already applied.
• Air valves can be mounted in every direction but are recommended to be mounted vertically with the pilot housing above
the valve body.
• Use the supplied 10 gauge wire or thicker (lower gauge #) wire to power your air compressor.
Recommended Tools
• 1/2” Wrench
• 9/16” Wrench (1/4” NPT Fittings)
• 7/8” Wrench (1/2” Banjo)
• 10mm Wrench or Socket (Air Source Mounting)
• 12mm Wrench
• Drill (3/16” & 7/16” Bits)
• Wire Cutter/Stripper
• Tubing Cutter/Razor
• Eye Protection
I. Installing Your Hornblasters Train Horns
Locate an area for your horns that is dry and free from debris. The horns can be mounted in any direction and still be heard
from all around. The horns should not be mounted where they will be completely submerged or will receive any kind of
impact. Horns may be mounted directly to your vehicle, on a medium such as grommet strips (plumber’s strap), sheet metal
or any sort of custom bracket. Note that air line will be running to each horns rear mount.
1. Locate a secure, dry, and safe position for your horns.
2. Make a mounting template by tracing the mounting bracket of the horn.
3. Using the mounting template, drill 3/16” holes for the mounting bracket of the horn.
4. Secure the horn using the supplied mounting hardware.
II. Installing Your Air Source Kit
Locate a flat and secure installation area that will remain free of dust, dirt, and debris (your compressors performance is
directly affected by air quality). Try to keep the distance of the unit from the battery to a minimum to keep your compressor
running at maximum performance.
1. Disconnect the ground cable from the vehicle’s battery.
2. Position the unit in the desired location and secure it using the supplied mounting hardware (10mm).
3. Remove the orange plug in the compressor’s inlet and mount the included air filter in its place.