Australian Monitor PM16 - Manual (Page 7)

PAGE 7 AMPRO PM12 & PM16 INSTALLATION & OPERATION MANUAL
STEREO CHANNEL SECTION
LEFT (MONO) / RIGHT
1/4 jack input connectors. This input is half-normalised, allowing a mono signal connected to the left input to be present on both
left and right output busses.
TRIM
Adjusts the input sensitivity of each channel.
EQ ON
Enables or disables the EQ. When the switch is depressed, the EQ is enabled. When the switch is in the “out” position, the EQ is disabled.
HIGH
Controls the high frequency response of each channel. Provides ±15dB at 12kHz.
MID
Controls the mid frequency response of each channel. Provides ±15dB at 2.5kHz.
LOW
Controls the low frequency response of each channel. Provides ±15dB at 80Hz.
AUX 1
This send is taken after the EQ section and pre fader (PRE-FADER, POST-EQ), and is therefore unaffected by the fader position.This is
particularly suitable for foldback or monitor feeds, which need to be controlled separately from the main PA Mix. The Aux feed is a mono
sum of both left and right audio signals.
18
19
20
21
22
23
24
18
19
20
21
22
23
24