Australian Monitor PM16 - Manual (Page 5)

PAGE 5 AMPRO PM12 & PM16 INSTALLATION & OPERATION MANUAL
MONO INPUT CHANNEL SECTION
BALANCE INPUT (MIC)
Electronically balanced inputs accept a standard XLR male connector. + 48V Phantom power available on each input mic socket.
LINE INPUT
Accepts an unbalanced high impedance input signal. (Use for connecting deck, turntable, keyboard etc..)
INSERT
Allows signal to be taken out from the mixer, routed through external equipment such as a compressor, and then back to the mixer to
continue the final mix path.
PHANTOM POWER SWITCH
Depressing this switch on each channel applies 48V DC across the microphone input XLR connector for remote powering of condenser
microphones. The LED will be turned on to indicate phantom power is enabled.
IMPORTANT: ONLY turn the +48V
phantom power switch on or off with
all output faders DOWN, to prevent
damage to the mixer or external devices.
LOW CUT
Depressing this switch inserts an 18 dB per octave, 75Hz low cut filter in the signal path. This is useful on live vocals to reduce stage rumble
or “popping” from microphones. It can also be used to cut low frequency hum.
TRIM
Adjusts the input sensitivity of each channel.
EQ ON
Enables or disables the EQ. When the switch is depressed, the EQ is enabled. When the switch is in the “out” position, the EQ is disabled.
HIGH
Controls the high frequency response of each channel. Provides ±15dB at 12kHz.
1
2
3
4
5
6
7
8
1
2
4
5
6
7
8
3