Hawk Industries T-Wrex Jr. Manual Serial Numbers 111 to 118 - Manual (Page 66)

66
Replacing Components
*Verify that all components (such as cables, hoses, etc.) are tagged and labeled during assembly
and disassembly of equipment to ensure correct installation.
*Replace failed or damaged components with Hawk certified parts. Failure to do so could result
in equipment damage or injury to personnel.
Recommended Tools
Service operations may require the use of tools designed specifically for the pupose described.
Hawk recommends that only those tools specified be used when stated. Ensure that personnel
and equipment safety are not jeopardized when following service procedures or using tools not
specifically recommended by Hawk.
Personnel Training
All personnel performing installation, operations, repair, or maintenance procedures on the
equipment, or those in the vicinity of the equipment, should be trained on the rig safety, tool
operation, and maintenance to ensure their safety.
*Only authorized Hawk repair technicians should perform major disassembly and assembly
procedures.
Safety Requirements
Hawk equipment is installed and operated in a controlled drilling rig environment
involving hazardous situations. Proper maintenance is important for safe and reliable
operation. Procedures outlined in Hawk manuals are the recommended methods of
performing operations and maintenance.
General Safety Practices
The equipment discussed in this manual may require or contain one or more utilities, such as
electrical, hydraulic, or pneumatic.
*Isolate energy sources before beginning work.
*Avoid performing maintenace or repairs while the equipment is in operation.
*Wear proper protective equipment during equipment installation, maintenance or repair.
General