Hawk Industries T-Wrex Jr. Manual Serial Numbers 111 to 118 User Manual
Page 23
23
(1)Extend unit fully.
(2)Loosen locking bolt, then tighten snug.
(3)Use 1 1/8” wrench to adjust T170 to starting point on cam.
(4)Tighten locking bolt enough to keep driving gear from rotating
during extend/retract operation.
(5)Retract unit 3-4 feet.
(6)Extend unit fully while observing which arm extends last.
rear arm extends before front arm,
adjust hex counter clockwise to increase flow
to front/reduce to rear.
front arm extends fully before rear arm,
adjust hex clockwise to increase flow to rear/reduce
to front.
Either back or front arms will extend last. Rotate adjust hex clockwise or counterclockwise accordingly.
Repeat setps 5 and 6 after each adjustment.
The closer the arms get to syncronization, micro adjustments are required.
Tighten lockbolt and tap adjusting wrench with deadblow hammer to make small adjustments.
Adjustment is complete when both front and back arms extend fully at the same time.
51141 SYNCRONIZATION ASSEMBLY ADJUSTMENT