American Electric Lighting LNH2 - Manual (Page 2)

American Electric Lighting a division of Acuity Lighting Group, Inc.
DRAWING NO. A72996 REV A (BACK) ©2014 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-70- 72996
CAUTION
DO NOT LEAVE THE PHOTOCONTROL COVERED
WITH THE BOX, OR OTHER MATERIAL, FOR
SEVERAL HOURS AS DAMAGE TO THE
PHOTOCONTROL, OR TO THE FIXTURE, MAY
RESULT
!
11. ENERGIZE THE FIXTURE BY TURNING ON THE
ELECTRICAL SUPPLY. TO CHECK THE OPERATION
OF THE FIXTURE DURING DAYLIGHT, COVER THE
PHOTOCONTROL WITH THE BOX THAT IT CAME IN.
(NEVER USE ALUMINUM FOIL OR ANY OTHER
ELECTRICALLY CONDUCTIVE MATERIAL TO COVER
THE PHOTOCONTROL.) THE FIXTURE SHOULD LIGHT
WITHIN 5 MINUTES.
NOTE: SOME MODELS OF PHOTOCONTROL WILL TURN THE
LIGHT ON AND IN A FEW MINUTES TURN OFF. THEN, AFTER
3 TO 5 MINUTES DELAY, IT WILL TURN ON. THIS IS NORMAL,
AND IT IS NOT A CAUSE FOR CONCERN. IT DOES NOT MEAN
THAT THE PHOTOCONTROL OR THE FIXTURE IS DEFECTIVE
(A DEFECTIVE PHOTOCONTROL WILL KEEP THE LIGHT ON
ALL DAY AND ALL NIGHT.)
12. REMOVE THE BOX FROM THE PHOTOCONTROL AND IT
WILL TURN OFF. AGAIN, THERE MAY BE A DELAY OF
SEVERAL MINUTES BEFORE THE LIGHT EXTINGUISHES.
THE FIXTURE IS NOW READY TO OPERATE
AUTOMATICALLY ON AT DUSK,OFF AT DAWN.
TESTING TESTING
DO NOT PULL DO NOT PULL
SIDEWAYS
SIDEWAYS
PULL STRAIGHT UP PULL STRAIGHT UP
THEN ROTATE
THEN ROTATE
PHOTOCONTROL PHOTOCONTROL
MOVEMENT
MOVEMENT
3-PIN
3-PIN
INSTALLING OPTIONAL PHOTOCONTROL INSTALLING OPTIONAL PHOTOCONTROL
(3 PIN - NO SCREWS)
(3 PIN - NO SCREWS)
7. LIFT AND ROTATE THE RECEPTACLE SO THAT THE ARROW
ON THE TOP POINTS NORTH. RELEASE THE RECEPTACLE.
PLUG THE PHOTOCONTROL INTO THE RECEPTACLE AND
TWIST IT CLOCKWISE UNTIL IT LOCKS INTO POSITION.
8. DOWNWARD PRESSURE SHOULD BE APPLIED TO THE
PHOTOCONTROL WHEN LOCKING OR UNLOCKING CONTROL
FOR REMOVAL OR INSTALLATION.
SPRING LATCH
OPTICAL
ASSEMBLY
NOTE NOTE:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
INSTALLING OPTIONAL PHOTOCONTROL INSTALLING OPTIONAL PHOTOCONTROL
(5 OR 7 PIN - WITH SCREWS)
(5 OR 7 PIN - WITH SCREWS)
9. LOOSE RECEPTACLE SCREWS, ROTATE THE RECEPTACLE SO
THE ARROW ON THE TOP POINTS NORTH. THEN TIGHTEN
THE SCREWS OF RECEPTACLE. PLUG THE PHOTOCONTROL
INTO THE RECEPTACLE AND TWIST IT CLOCKWISE UNTIL
IT LOCKS INTO POSITION.
CAUTION
DO NOT OVER ROTATE THE RECEPTACLE.
NO MORE THAN 360 DEGRESS.
!
PHOTOCONTROL
SCREWS
(5&7 PIN)