American Electric Lighting Series LNH - Manual

INSTALLATION INSTRUCTIONS
SERIES NEMA LED
American Electric Lighting a division of Acuity Lighting Group, Inc.
DRAWING NO. A72678 REV A (FRONT) ©2011 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-71-72678
1. FEED THE WIRES THROUGH THE RUBBER BIRD
SHIELD INSIDE THE HOUSING, DRESS THE WIRES
SO THEY DO NOT INTERFERENCE WITH ANY
COMPONENTS.
2. TIGHTEN THE FITTER BOLTS SECURELY.
3. LEVEL THE FIXTURE USING THE LEVELING SCREW.
4. LOOSEN (DO NOT REMOVE) THE FITTER BOLTS. LIFT
THE LUMINAIRE INTO POSITION IN FRONT OF THE MAST
ARM SUCH THAT THE MAST ARM ENTERS THROUGH THE
OPENING AT THE REAR OF THE LUMINAIRE AND BETWEEN
THE FITTER BRACKET AND THE LUMINAIRE HOUSING.
TIGHTEN FITTER BOLTS TO 10-12 FT-LBS
WIRING THE FIXTURE
5. REMOVE OPTICAL ASSEMBLY FROM THE HOUSING.
DETACH THE TWO SPRING LATCHES OF THE
OPTICAL ASSEMBLY. PULL LATCH UP. OPTICAL
ASSEMBLY WILL BE SUPPORTED BY A TETHER THAT
IS ATTACHED TO THE HOUSING.
6. CONNECT THE WIRES TO THE PROPER TERMINALS ON
THE TERMINAL BLOCK. REFER TO THE WIRING
DIAGRAM FOR CONNECTION INFORMATION.
RECOMMENDED TORQUE FOR TERMINAL BLOCK
SCREWS 35 IN-LBS.
INSTALLING THE OPTICAL ASSEMBLY
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
HOUSING MUST BE GROUNDED TO REDUCE POTENTIAL OF ELECTRICAL SHOCK
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION
WARNING
!
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. FOR CODE INTERPRETATION,
CONSULT LOCAL CODE AUTHORITY BEFORE INSTALLING VERIFY THAT THE SUPPLY VOLTAGE
MATCHES THAT REQUIRED BY THE FIXTURE AS SPECIFIED ON THE DATA LABEL.
RISK OF FIRE. PRODUCT FOR OUTDOOR INSTALLATION AND USE ONLY.
WARNING
CAUTION
!
!
7. ATTACH SPRING LATCHES OF OPTIC TO THE TABS ON
THE SIDE OF THE HOUSING AND PULL LATCH HANDLE
DOWN TO LOCK IN PLACE.
MOUNTING THE FIXTURE
FITTER BOLTS
OPTICAL
ASSEMBLY
TETHER
LEVELING SCREW
BIRD SHIELD
FITTER BRACKET
LUMINAIRE HOUSING