Pulsafeeder PULSAtron Series MP EN - Manual (Page 23)

23
ADDITIONAL SETTINGS:
“Flow Verify?” – used in conjunction with the flow verification meter; to activate this option:
Choose:
“Settings?”, press “YES”
“Flow Verify?”, press “YES”
“Yes=On No=Off?”, press “YES”
NOTE: Enabling flow verification on a pump with no flow meter will cause a flow failure.
“Factory Init?” – initializes the pump back to all original factory settings; to reinitialize the pump:
Choose:
“Settings?”, press “YES”
“Factory Init?”, press “YES”
“Init Settings?”, press “YES”
“Are You Sure?”, press “YES”
“Volume-Units?” – allows the user to select how the flow data will be displayed (default is GPD); to change this setting:
Choose:
“Settings?”, press “YES”
“Volume-Units?”, press “YES”
Use the up and down arrow to choose GPD, GPH, or LPH. Choose “YES” when the desired unit is
displayed.
“Reset Totals?” – resets the flow totals; to reset the totals:
Choose:
“Settings?”, press “YES”
“Reset Totals?”, press “YES”
“Are You Sure?”, press “YES”
The display will read “Reset Done”, press “YES” to get back to the settings menu.
“Calibrate Flow?” – allows the user to calibrate the system to obtain accurate flow totals; to calibrate the system:
Choose:
“Settings?”, press “YES”
“Calibrate Flow?”, press “YES”
“Stroke=100%”, use arrow keys to set the stroke per the dial, press “YES”
“Run Calib?”, press “YES”
Run the pump for the desired amou
nt of time while measuring the flow output. Press “YES” to stop the
calibration period. Use the arrow keys to enter the measured flow in mL, press “YES”. The display will
read “Calibrated”, press “YES” to return to the Settings menu. NOTE: If the stroke length is changed and
the calibration is not re-run, the flow totals will not be accurate.
Additional Relay Functions: “Rel-Flow Vrfy?” – allows the relay to be activated if there is a flow failure. To set this option:
Choose:
“Settings?”, press “YES”
“Rel-Flow Vrfy?”, press “YES”
“Language?” – allows the user to select English (default), German, Spanish or French; to set the language:
Choose:
“Settings?”, press “YES”
Use the arrow keys to select the desired language, press “YES”.