Amana Bottom-Freezer Refrigerator - Manual (Page 7)

➢ To remove panels, remove door han-
dle and slide panel out the handle side
of door.
➢ Install panels by sliding panel in
grooves provided by bottom door cap
and side trim.
➢ Replace the
handles, when
completed.
7
How to replace the
doors and hinges
1. Install hinge assemblies.
2. Install center hinge with Phillips
screws.
3. Install stabilizing bracket with 3 Ú
8
" hex
head screws.
4. Install center
hinge pin with 5 Ú
16
"
hex head driver.
5. Place hinge side of refrigerator door
on center hinge pin.
6. While holding refrigerator door
upright, tighten down top hinge with
5 Ú
16
" hex head driv-
er. Replace hinge
cover (some mod-
els).
To avoid personal injury or property
damage, fresh food panel should not
weigh more than 30 lbs (14 kgs) and
freezer panel should not weigh more
than 15 lbs (7 kgs).
WARNING
How to remove and
install panels
(SOME MODELS)
WHAT IF I AM INSTALLING
RAISED PANELS?
If raised panels are used, allow 2 1 Ú
2
" (A)
minimum clearance between raised edge
of panel and handle.
Please see the recommended dimen-
sions for panelling.
Raised Panel B – 42" x 35 5 Ú
8
"
(106.7 cm x 90.5 cm)
Raised Panel C – 23 1 Ú
4
" x 36 1 Ú
16
"
(59.1 cm x 91.6 cm)
B
C