Agilent Technologies N9360A - Manual (Page 24)

4-6 N9360A Multi UE Tester Quick Reference Guide
4 GSM System
Figure 4-5 Various [Manual Test (GSM): Stand-by] Screens
7 While “Connection” is highlighted in the test flow, press the
Trigger
softkey to start single measurement or the Trigger
Sing/Cont softkey to start continuous measurement. Press the
Trigger Sing/Cont softkey again to terminate the continuous
measurement.
8 Place the cursor at one of the groups of the test items and
press the knob or press the Spectrum Monitor softkey to display
a measurement result screen according to your selection.
Then, press the Trigger softkey to start single measurement or
Trigger Sing/Cont
softkey to start continuous measurement.
Spectrum
Monitor
Sensitivity
RX Quality
RX Level
Phase Error
Frequency Error
Peak TX Power/ Burst
Timing/ Power Ramp