Ameriphone DIALOGUE XL 50 - Manual (Page 6)

Setting up Your
Dialogue XL-50
There are five steps involved in set-
ting up your Dialogue XL-50.
• Insert four AA alkaline batteries
for back-up in case of AC power
outage.
• Decide if you want the phone to
sit on a desk or hang on the wall.
• Connect the telephone components.
• Program up to to 12 telephone
numbers to call with the press of
a memory button.
• Setup special features
Installing the Backup Batteries
If there is a power outage, the
Dialogue XL-50 will operate for up to
48 hours with four AA alkaline back-
up batteries (not included). If the
phone is not in use, the batteries will
stay charged for several months.
To install new batteries:
1. Slide open the battery compart--
ment cover on the bottom of the
telephone (Figure 3).
2. Install four fresh batteries. Be
sure to observe battery polarity
as imprinted on the base of the
compartment. The battery indi-
cator on the top panel will light
up if the batteries are running low.
The phone operates as a regular
phone if there is no power or battery.
XL-50 Low Battery Indicator
If the batteries in the are weak or not
installed the low battery indicator will
light up. Install fresh batteries accord-
ing to the directions above.
Connecting for Desk or Wall Mount
Set the dial mode switch to T (tone)
if you have touch tone service. Set
the switch to P (pulse) if you have
rotary dialing.
Insert
batteries
here
Press in
here
to open
battery
compart-
ment
Figure 3 - Accessing the Batteries
4
HOLD PROG
TONE
LO HI
FLASH REDIAL
VOL
AMPLIFY
Figure 4 - Low Battery Indicator